Installing the hardware
8
SAGEM F@st™ 1400 / 1400W
2.2
Powering up the modem/router
• Connect the cable (4) to the
PWR
port located on the rear panel of the modem/router.
• Connect the power pack to a nearby socket.
• Set the On/Off switch (I/0) to On (the "
I
" position).
The
PWR
LED comes on.
In no event should you connect your modem/router to a single computer using
the USB and Ethernet cables simultaneously.
You can now connect your computers to the SAGEM F@st™ 1400/1400W
modem/router:
• via the USB interface,
see chapter 4 "Connection via the USB port" ........................................................ page 12
• via the Ethernet interface,
see chapter 3 "Connection via the Ethernet port" ................................................. page 10
• via the wireless network interface (SAGEM F@st™ 1400W only)
see section entitled "Configuring the wireless network" ........................................ page 22
After a few minutes, the modem/router is
automatically synchronized with your ADSL
line. The
LINE
LED comes on permanently.
On/Off switch (I/0)
(4)