Sage the Boss To Go, Instruction Manual

Page: 4 / 76

4
Safety switches with a rated
operating current not more
than 30mA are recommended.
Consult an electrician for
professional advice.
• Always ensure the appliance is
properly assembled before use.
The appliance will not operate
unless properly assembled.
• Do not use the appliance
on a sink drain board.
• Keep hands, fingers,
hair, clothing as well as
spatulas and other utensils
away from moving or rotating
parts during operation.
• Do not use the appliance
for anything other than food
and/or beverage preparation.
• In order to avoid the possible
hazard of the appliance
starting by itself due to
inadvertent resetting of the
overload protection, do not
attach an external switching
device (such as a timer)
or connect the appliance to
a circuit that can regularly
switch the appliance on
and off.
• Carefully read all instructions
before operation and save for
future reference.
• The appliance can be used by
persons with reduced physical
or mental capabilities or a lack
of experience and knowledge,
only if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• This appliance shall not be
used by children.
• Do not leave the appliance
unattended when in use.
• Allow the motor to rest for
1 minute between each use.
• Do not place any part
of the appliance in the
microwave oven.
• Be careful when handling and
cleaning blades, as they are
very sharp. Mishandling of
the blades may cause injury.
• Avoid putting the cup or jug
on the motor base while the
motor is still spinning.
• Do not operate without any
ingredients in the cup or jug.
• Never attempt to operate
with damaged blades, or
with utensils, or any foreign
objects inside the cup or jug.
• Do not put the cup or jug in
extremes of heat or cold, for
example placing a cold jug
into hot water, or vice versa.
• Blades must be firmly
secured to cup before
operation to ensure
internal con-tents do not
escape or spray.
• Never attempt to operate
or place the blade assembly
onto the motor base without
the cup in place.