= Inspect
= Verify
= Perform process
Page 34 of 45
Document No: 723590-1
Revision: D
Issue Date: 2023-Jan-30
This document and all copies are the property of Safeworks, LLC. All dimensions and data are indicative only.
The user must ensure that the equipment complies with local rules and regulations.
10. DE-REEVING
10.1 Removing the Optional Secondary Suspension Wire Rope
Verify hoist is secure in the stirrup mount prior to applying slack in the primary suspension
wire rope. In order to remove the secondary suspension wire rope, there must be no slack on the
primary suspension wire rope and the platform must be supported on a flat, stable surface.
Remove the counterweight from the end of the secondary suspension wire rope.
P
ull the secondary suspension wire rope out of the hoist by hand.
If necessary, the primary suspension wire rope can now be removed from the hoist.
10.2 Removing the Primary Suspension Wire Rope
For hoists equipped with the optional secondary wire rope, the secondary wire rope must
be removed before the primary wire rope is removed.
CAUTION:
To prevent hoists and platform from tipping and avoid injuries, ensure that the platform
is properly supported on a flat, stable surface before putting slack on the primary
suspension wire rope.
Verify that platform is supported by a flat, stable surface before putting slack on the primary
suspension wire rope.
Push in the
DOWN operation button to wind the primary suspension wire rope out of the
hoist. To remove the last 15 inches (40 cm) of wire rope, if necessary, grab the wire rope above
the insertion point, hold the overspeed brake reset knob in the reset position (vertical) and slowly
pull the primary suspension wire rope out of the hoist.
