Roof Reach Assembly Instructions
Continued
Step 8
Place the counterweight plates onto the round
receivers on the back of the body rear
assembly (beneath the handles). Six weights
should be placed on each side, and all 12
weights must be used.
Step 9
Four workers may then push the unit into position.
Once in position, deploy all four leveling jacks until
the wheels of the unit are off the surface. Using
the level located on the body front assembly, make
sure the unit is level.
Step 10
Attach SRLs to the loop connections at the end of the
arm with double locking carabiners.
Attach SRL snap hook to the back D-ring of the workers
properly fitted full body harness.
!! WARNING !! WHEN CONNECTED TO THE ROOF REACH
IT MUST BE FULLY SET-UP AS INSTRUCTED ABOVE AND
ALL 4 JACKS MUST BE DEPLOYED WITH THE SYSTEM
LEVEL TO ENSURE ALL WHEELS ARE OFF OF THE
GROUND.
