Securing Child in Child Restraint
11
12.
From the Back, Pull
Harness Straps Through
Shell
Harness straps
MUST
be in shoulder
harness slots
BELOW
the metal bar as
shown.
DO NOT
twist harness straps.
13.
Attach 2nd Harness Strap
Loops to Splitter Plate As
Shown
Sewn ends of the harness strap loops
MUST
face towards you.
DO NOT
twist harness straps or harness
adjustment strap.
Make sure the same harness strap loops
are fitted
COMPLETELY ON
both sides
of the splitter plate.
Replace headrest pad around bottom
of headrest.
sewn
end
12
1.
Place Child in Child
Restraint
The child’s bottom and back should be
flat against the child restraint.
Position harness strap over child’s
shoulders and upper thighs.
3.
Close Chest Clip
Insert right half of chest clip into left half
and snap together.
2.
Buckle Harness
Push buckle tongues into buckle until you
hear them “click.”
Pull up on harness strap to make sure
buckle is locked.
4.
Tighten Harness
Pull on harness adjustment strap to
tighten harness snugly.
continued on next page
Correct
WARNINGS:
Harness system must be installed correctly. The
harness strap must be returned to the upper shoulder harness slots
as your child grows.
Failure to follow these steps can result in serious injury or death.
11.
Pull Bottom of Headrest
Pad Off of Headrest
Thread harness straps through slots in
headrest pad.
Thread harness straps through lower
shoulder harness slots in headrest and
through the slots in seat back (shell).
5.
Position Chest Clip
The chest clip must be placed at mid-
chest (even with armpits) and away from
the child’s neck.