XXXXX
WARNINGS:
Do not use the Universal
Anchorage System (UAS) when using the
vehicle lap or lap/shoulder belt. Secure
UAS to storage attachments as shown
when installing with vehicle belts.
Secure the tether hook when used rear
facing. Attach the tether hook to storage
attachment as shown and gently tighten to
remove slack.
Check vehicle belt before each use. Use
only if the belt can be tightened properly
and locked securely in place.
Failure to follow these warnings can result
in serious injury or death.
Vehicle Belt Installation
40
continued on next page
Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-5.
Experts agree that children should remain rear facing as long as
possible. In this child restraint, your child can remain rear facing up
to 18 kg (40 lb) and up to 102 cm (40 in.).
1.
Fully Recline the Child
Restraint
Pull out on recline handle and push top
of child restraint back.
39
2.
Place Child Restraint Rear
Facing in Back Seat
The level line on shell
MUST
be parallel
with the ground.
3.
Route Vehicle Lap or
Lap/Shoulder Belt Through
Rear-Facing Belt Path
Review pages 31-32 and your vehicle
owner’s manual to determine what kind
of vehicle belts you have and how to
lock a child restraint in place.
4.
Reach Under Pad and Pull
Vehicle Belt Across the Shel
l
Do not twist belt.
Belt
MUST
be in front
of buckle strap.
You
MUST
use the 1st or 2nd buckle
slot. Do not place belt over child’s legs.
Buckle vehicle belt.
1
2
3
5.
You MUST Thread Only
the Lap Belt Through
Rear-Facing Belt
Positioning Guides on
Both Sides of Shell
Do
NOT
thread the shoulder belt in either
of the rear-facing belt positioning guides.