17
18
Installing Harness System
WARNINGS:
Do not use child restraint without the
seat pad. Failure to do this can result in serious injury or
death.
Cleaning Pad and Accessories
Machine wash separately with cold water on a gentle cycle. Do
not use bleach. Tumble dry separately for 10-12 minutes on
low heat. Remove immediately.
Cleaning Harness Straps
Spot clean using warm sudsy water and damp cloth.
Replacing Pad
Adjust the headrest to the highest position. Starting from the
bottom, gently pull headrest pad onto headrest. Make sure
headrest airbags stay in place.
Starting from bottom of child restraint, slip pad on shell. Pull
harness adjustment strap through pad.
Tuck the seat pad behind the bottom fl ap of
the headrest.
Fit the pad around the shell and tuck the pad
under cup holder.
Stretch pad over the side and reconnect the
pad tab into the lower slot on both sides.
Push pad behind headrest. Wrap around the top of shell.
2.
Insert Buckle’s Metal
Retainer into Slot
Closest to Child
Buckle
MUST
face out. You
MUST
use the 1st or 2nd buckle slots
when child restraint is used rear
facing.
Any slot can be used when
forward facing.
1.
Fully Recline the Child
Restraint
Squeeze up and then pull out on
the recline handle and push top of
child restraint back.
3.
Reach Under Seat
Between Base and Shell
Pull metal retainer completely
through pad and shell.
1
2
3
continued on next page