SafeHome WS200X, User Manual, Page: 27 / 106

www.safehome.dk www.safehome.dk 8
9
3.2 Panic Alarm
3.2.1 Using the Panic Alarm
Pressing + buttons together on the Keypad / Remote Control will immediately
activate the siren, and transmitting an alarm signal to any optional response devices
(Camera/APP& Outdoor Bell Box & GSM Device), to request emergency assistance.
To disarm the Panic alarm
On the Smart Panel: Enter your 4-digit PIN followed by to exit from the Panic alarm.
On the Remote Control: Press
3.2.2 Using the Panic alarm without activating the siren
If you are forced to disarm the system, enter the Duress Password to stop the siren from
sounding. The Smart Panel will then silently transmit an alarm signal to the optional
response devices (Camera/APP & GSM Device) to request emergency assistance.
Duress Password:
Enter the default or your personalized 4-digit PIN + followed by
3.3 Operating different Modes
The system has 4 operating modes (STANDBY, ARM, ALERT, and HOME) to suit
individual requirements.
3.3.1 STANDBY Mode
In STANDBY mode the Smart Panel is disarmed and prepared for mode selection.
You must be in STANDBY mode before turning to other modes.
From other modes to STANDBY
mode, enter the default or your personalized 4-digit PIN
followed by .
3.3.2 ARM Mode
If in ARM Mode, the Smart Panel alarm will sound and the Smart Panel (All in RED)
flashes every 1.5 seconds when the system is triggered.
ARM mode default setting:
Zone Status (MODE)
Door/Window Sensor 1 ARM
Motion Sensor (PIR) 8 ARM
Camera 6 ARM
A. Arming the System
On the Remote Control: Press to activate.
On the Smart Panel: First make sure the Smart Panel is in STANDBY mode, and then
ARM the system by following steps below:
Step Keys Description Note
1
PIN +
You must be in
READY mode
before
programming To make sure you are in READY
mode:
Enter your PIN
Press
the symbol disap-
pears from the screen.
2 From READY Mode
to ARM mode There is a 20 seconds exit delay
time with a visual and sounds count
down before the system is armed.
(Press Mute to disable the count-
down sounds, Press Mute again to
resume the sounds)
If the Zone is enabled, a number will
appear as displayed in the image
below:
The System will then enter ARM
mode after 20 seconds.
When in ARM mode, the Smart Panel flashes RED every 5 seconds, acting as a deter-
rent to potential intruders. However, if an intruder is detected the panel continuously and
rapidly flashes RED.
Once an intrusion has occurred (with the zone triggered under ARM status), the alarm
will start entry delay countdown (factory set is 30 seconds). After countdown the siren
will sound and the Smart Panel flashes RED every 1.5 seconds with the triggered zone
indicated. After the initial triggering, the alarm will immediately sound, without delay, if
any other sensors are triggered.
B. Disarming the System
On the Smart Panel: Enter your 4-Digit PIN followed by to disarm the system.
On the Remote Control: Press to disarm the system.