Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
24
Rear
Front
M8 X 20MM
Lock Washer
Flat Washer
Rear
Front
Lef
t
Right
9.125”
Crossbar Rear
Crossbar Front
(B) 48.00” ErgoRack
41.00” AluRack
(A) 96.00” ErgoRack
102.50” AluRack
(B) 48.00” ErgoRack
61.50” AluRack
2.4
Insert one Aluminum Strip Nut
into the upper slot of each of
the rear Channels.
Set to distances shown below:
Use Dimensions A for 2 Crossbar models.
Use Dimensions B for 3 Crossbar models.
Do not torque the Crossbar Mounting Brackets until Step 3.4.
Finger-tighten them into designated dimension to hold them in
place, then proceed to your Feature (FEA) Assembly Manual.
2.3
Loosen nuts
3 Crossbar models:
Position the center
Mounting Brackets
as shown.
*2 & 3 Crossbar models:
Position the front Mounting
Brackets as shown.
MOUNTING BRACKETS
2.2
2.1
Slide the Aluminum Strip Nuts into each end of the Channels,
and attach the Channel Caps
Do not mount the Crossbars to this FBM system at this time.
Refer to the respective FEA Assembly Manual(s) included
with your chosen rack configuration features. Depending
upon the features chosen, you may need to perform a
complete feature assembly onto the Crossbars as noted in
that feature’s Assembly Manual.
WARNING: Failure to position the Crossbars as shown in this
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
NOTE:
Base, Clamp Down, or Rotation features are not
included in this FBM kit, and must be purchased separately.
To purchase applicable features and accessories, please
contact your authorized distributor, or a Prime Design Sales
& Service Representative.
Using the supplied fastening hardware, attach the Crossbar
Mounting Brackets into the Aluminum Strip Nuts placed into
the Channels at Step 2.1
FBM-1007
ASSEMBL
Y INSTR
UCTIONS–L5H2 MOUNTING
*2 Crossbar ErgoRack models:
See Page 24 regarding center
Crossbar Mounts.
Summary of Contents for Prime Design FBM-1007
Page 28: ...USAM FBM1007 US01 Rev A 0720 ...
