Safe Fleet Prime Design FBM-1007, Manual

Page: 15 / 28

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
15
Rear
Front
M8 X 20MM
Lock Washer
Flat Washer
Rear
Front
Lef
t
Right
9.125”
Crossbar Rear Crossbar Front
(B) 32.00”
80.00”
48.00”
FBM-1007
ASSEMBL
Y INSTR
UCTIONS–L2H2 UNIVERSAL FBM
2.4
Set to distances shown below (AluRack only). Do not torque the
Crossbar Mounting Brackets until Step 3.4. Finger-tighten them
into designated dimension to hold them in place, then proceed
to your Feature (FEA) Assembly Manual.
2.3
Loosen nuts
MOUNTING BRACKETS
2.2
2.1
Slide the Aluminum Strip Nuts into each end of the Channels,
and attach the Channel Caps
Do not mount the Crossbars to this FBM system at this time.
Refer to the respective FEA or AR Assembly Manual(s)
included with your chosen rack configuration features.
Depending upon the features chosen, you may need to
perform a complete feature assembly onto the Crossbars or
Side Rails as noted in that feature’s Assembly Manual.
WARNING: Failure to position the Crossbars as shown in this
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
NOTE: Crossbars, Side Rails, Base, Clamp Down, or Rotation
features are not included in this FBM kit, and must be
purchased separately. To purchase applicable features and
accessories, please contact your authorized distributor, or a
Prime Design Sales & Service Representative.
Using the supplied fastening hardware, attach the Crossbar
Mounting Brackets into the Aluminum Strip Nuts placed into
the Channels at Step 2.1