Determine the position for the half-sleeves on the
D 42" Posts w/Caps & Levelers. (TIP: Hold a 42"
Post next to the connected
posts from step #9 with the levelers
resting on the table top). Slide the
cap ends of the posts into
two corner holes of the
F 48" x 18" Wire Shelf until the
connected half-sleeves are inside
the holes.
10
Q
Q
Q
Q
Q
5210-37: 3 of 4; Rev. 3, 08/00
Safco Products Company, New Hope, MN 55428
Raise the 48" x 18" shelf and 42" posts from step
#10 up so the two empty holes along the back
edge of the shelf are over the connected posts on
the workstation. Slide the corner holes down over
the posts and half-sleeves. (
NOTE:
this is easier
with a helper).
11
Press the shelf corners down firmly over the half-
sleeves. Snap one pair of half-sleeves to the top
groove of each of the four shelf posts at the top of
the workstation.
12
36" POST
W/CAP
Q
Q
Q
Q
Q
HALF-
SLEEVE
TABLE TOP
48" x 18"
WIRE SHELF
42" POSTS W/CAPS
& LEVELERS
HALF-SLEEVE
42" POSTS W/CAPS & LEVELERS
48" x 18"
WIRE SHELF
CONNECTED
POSTS
HALF-SLEEVE
To build the two back
corner posts, screw the B
Lower Posts (with levelers)
onto the C Upper Posts
(with plastic caps). Hand
tighten.
Attach two sets of Q Half-
Sleeves to these connected
posts at desired height of
lower shelf. (
NOTE:
there
should be a minimum of
18" between upper and
lower shelves).
9
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
B
Q
Q
Q
Q
Q
C
Q
Q
Q
Q
Q
