Saf-Fro DIGISTEEL III 320C, Operation And Maintenance Instructions, Page: 25 / 28

DIGISTEEL III 320C / DIGIPULS III 320C
6.2. ADVANCED WELDING CYCLE
2- Step cycle
Pressing the trigger activates wire feed and pre
The Hot Start cycle is validated by the
tHS
≠
OFF
a current peak that facilitates striking.
The down-slope enables weld bead finish with a decreasing level of welding
4- Step cycle
Pulling the trigger the first time activates the pre
If HOT START is not active, welding will start immediately after pre
welding cycle will continue.
Pressing the trigger in the welding phase (3rd step) enables control of the duration of the down
programmed time delay.
If there is no down-slope, releasing the trigger will immediately switch into post
In 4-Step mode (4T), releasing the trigger stops the anti
If slope-down is DISABLED, releasing the trigger will stop the POST
The Hot Start and slope-down functions are not available in manual mode
320C
LE
Pressing the trigger activates wire feed and pre-gas and turns on the welding current.. Releasing the trigger causes the welding to stop.
OFF parameter in the general Cycle submenu of the SETUP. It enables starting the welding with
slope enables weld bead finish with a decreasing level of welding.
Pulling the trigger the first time activates the pre-gas, followed by Hot Start. Releasing the trigger starts the welding.
If HOT START is not active, welding will start immediately after pre-gas. In such a case, releasing the trigger (2
nd
step) w
Pressing the trigger in the welding phase (3rd step) enables control of the duration of the down-slope and anti-crater functions, according to the pre
slope, releasing the trigger will immediately switch into post-gas (as programmed in the Setup).
Step mode (4T), releasing the trigger stops the anti-crater function if slope-down is ENABLED.
down is DISABLED, releasing the trigger will stop the POST-GAS.
down functions are not available in manual mode
Wire speed
Arc length
EN
25 / 28
gas and turns on the welding current.. Releasing the trigger causes the welding to stop.
parameter in the general Cycle submenu of the SETUP. It enables starting the welding with
gas, followed by Hot Start. Releasing the trigger starts the welding.
step) will have no effect, and the
crater functions, according to the pre-
gas (as programmed in the Setup).