Saf-Fro DIGISTEEL III 320C, Operation And Maintenance Instructions, Page: 11 / 28

DIGISTEEL III 320C / DIGIPULS III 320C
Create and save a program :
These paragraphe explains how to create, modify and save a welding program.
1) Activate program management mode SETUP
2) Set your program with commutators then long push on button OK
3) Screen displays message as following:
NOTE : The DIGISTEEL III 320C / DIGIPULS III 320C
The locking key entered has to be written in order to desactivate the function lock.
3.3.5. Program call with trigger
This function allows to chain from 2 to 10 programs. This function is available in 4T welding mode
Program chaining
:
The function program call works with programs from P50 to P99 by ten.
P50 P59 ; P60 P69 ; P70 P79 ; P80
Selec first program with which you want to begin your chain. Then during welding, each time you will push trigger
To chain less than ten programs, in the program following end of loop desired put a different parameter (As syne
It is possible to setup time of trigger push to detect change of program chain : SETUP
Example : Create a program list from P50 to P55 (6
1) In program P56, put different welding c
2) Select program P50 (First program for start of welding
3) Start welding
4) Each time trigger will be pushed, power source will change program until P55.
Function selection:
rEC : Save program
Ld
: Load program
cod : Activate locking
code
Cancel action in
progress.
320C
dify and save a welding program. Hereunder is explained the common menu used.
Activate program management mode SETUP PGM put YES exit SETUP
Set your program with commutators then long push on button OK
Screen displays message as following:
/ DIGIPULS III 320C allows to lock program menu. This function is available on program screen with the parameter cod.
The locking key entered has to be written in order to desactivate the function lock.
from 2 to 10 programs. This function is available in 4T welding mode only and program management mode has to be activated
with programs from P50 to P99 by ten.
P79 ; P80 P89 ; P90 P99
Selec first program with which you want to begin your chain. Then during welding, each time you will push trigger, program will change.
program following end of loop desired put a different parameter (As synergy or welding cycle).
It is possible to setup time of trigger push to detect change of program chain : SETUP CPT put value from 1 to 100
: Create a program list from P50 to P55 (6 programs).
lding cycle or synergy than P55 in order to finish chain
Select program P50 (First program for start of welding
Each time trigger will be pushed, power source will change program until P55. When chain is finished, power source will restart to P50.
EN
11 / 28
Hereunder is explained the common menu used.
allows to lock program menu. This function is available on program screen with the parameter cod.
only and program management mode has to be activated
program will change.
rgy or welding cycle).
put value from 1 to 100 exit SETUP
When chain is finished, power source will restart to P50.
Program number
selection.from
P01 to
P99
.
P00 : Cancel program
mode
Validate action in
progress