32
English
8
PROGRAMMING AND
MAINTENANCE MENU
Important
This section illustrates how to set up or modify the machine
programming and maintenance parameters.
The section should therefore be read carefully, to fully
understand the correct sequence of operations to be
performed.
8.1
Description of
programming and
maintenance
phase keys
To surf inside the menu of the vending machine use the
keys described below.
key
e
: ENTER (7 - Fig. 59)
Pressing this key it is possible to access the following level
of programming or maintenance. Furthermore it is possible
to modify or confirm the values set in the entries of the
programming or maintenance menus.
Key
c
: CANCEL (8 - Fig. 59)
Pressing this key it is possible to go back to the previous
level of the programming or maintenance menu. It is also
possible to avoid storing the values of the previously
required modifcation.
Key V: DOWN (9 - Fig. 59)
Pressing this key it is possible to access the preceding entry
inside the same level.
If used after requesting the change of a datum, it decreases
the value of the same datum.
Key : UP (10 - Fig. 59)
By pressing this key it is possible to access the following
entry inside the same level.
If used after requesting the change of datum, it increases
the value of the same datum.
Fig. 85
1
8.2
Programming menu
The structure of the programming menu is shown in 8.2.2.
At 8.2.3 all of the entries present in the programming menu
are described.
8.2.1
Entering the
programming menu
Open the upper door, disable the safety device (see 3.4)
and press key
1
(Fig. 85) to access the programming menu.
If no password has been assigned you enter the
programming menu directly.
Important
If vending machine was assigned a password to enable
the programming menu, “PASSWORD 0000” will appear
on display with a flashing cursor on the first digit.
Now enter the password using
UP
and
DOWN
keys.
Confirm the entered digit by means of
ENTER
key.
To exit the programming menu and return to the normal
operation of the vending machine:
-
press key
1
again;
-
remove the key from the safety switch, thus switching
off the vending machine;
-
close the door and wait for the end of the self-
configuration process.
^
Summary of Contents for D.A. COMBISNACK
Page 67: ...67 English...
Page 68: ...Cod 0875 971 Ed 02 10 03...
