Saeco CRISTALLO 400, Use And Maintenance

Page: 27 / 64

27
English
Fig. 59
8 PROGRAMMING AND
MAINTENANCE MENU
Important
This section illustrates how to set up or modify the vending
machine programming and maintenance settings.
It is therefore necessary to read it carefully, and intervene
only when the correct sequence of operations to be performed
is fully understood.
8.1 Key description of
programming and
maintenance phases
To scroll through the vending machine menu, the keys
described below are used.
“e” Key: ENTER (4 - Fig. 58)
By pressing this key it is possible to enter the following
programming or maintenance level. It is also possible to
modify or confirm the values set in the entries of the
programming or maintenance menus.
“c” Key: CANCEL (3 - Fig. 58)
By pressing this key it is possible to go back to the previous
level of the programming or maintenance menu. It is also
possible to avoid storing the previously modified values.
“V” Key: DOWN (2 - Fig. 58)
Pressing this key it is possible to access the previous entry
inside the same level.
If used after a setting modification request, the value of this
setting decreases.
“
^
”Key: UP (1 - Fig. 58)
By pressing this key it is possible to access the next entry
inside the same level.
If used after requesting the change of a setting, the value of
this setting increases.
8.2 Programming menu
The structure of the programming menu is shown in 8.2.2.
8.2.3 describes all the entries in the programming menu.
8.2.1 Entering the
programming menu
Open the door, disable the safety device (see 3.4) and press
the P1 key (Fig. 59) to enter the programming menu.
If no password has been assigned, the programming menu
is entered directly.
IImportant
If a password was assigned to the vending machine to enable
the programming menu, the message “PASSWORD 000000”
will appear on the display with a flashing cursor on the first
digit.
Now the password should be entered using the UP and
DOWN keys. Confirm the digit entered by pressing the
ENTER key.
Proceed as follows to exit the programming menu and return
to standard operation of the vending machine:
- press the
P1
key again;
- remove the key from the safety switch in order to turn
off the vending machine;
- close the door and wait for the self-configuration process
to end.
e
c
Fig. 58
^
^
P1