Saeco CAP020, Operation And Maintenance

Page: 102 / 228

English
9
102
9.7 Brew Buttons Programming
The beverage quantities associated to the corresponding
buttons, can be directly programmed through the keypad.
To program and re-program the buttons, follow the
instructions below:
Coffee quantity:
• Switch on the machine and set it up for use.
• Place the container under the specific dispensing spout.
• Press and hold the button corresponding to the coffee
beverage to be programmed
• The display shows the programming icon, as shown in the
figure;
• Release the button to store the dispensed dose.
Milk quantity:
The option “MILK PROGRAMMING” is a control inside
the programming menu.
Refer to chapter 8, section 8.2.6.
9.8 Display Messages
A list of alarms (in addition
to those explained before)
that can be displayed and
the
relative machine
conditions is given below.
STANDBY
The machine is switched off (the power button is set to
“I”) and the automatic switching-on/off function is enabled
(see section “Description of Messages in the Programming
Menu”).
LOAD THE CIRCUIT
This message is displayed when the machine detects no
water in the boilers during a beverage dispensing cycle.
After checking if there is actually water in the water
network, press the “Up” button (in the COFFEE version),
until water comes out regularly from the wand and from
the coffee dispensing spout. In the COFFEE version water
comes out from the coffee dispensing spout only.
EMPTY GROUNDS
It is displayed when the coffee grounds drawer is almost
full (the machine has performed the programmed number
of brewing cycles).
Anyway, more brewing cycles can be performed.
OUT OF SERVICE – EMPTY GROUNDS
The coffee grounds drawer is completely full (the machine
has performed the programmed number of dispensing
cycles).
The machine is blocked and no more dispensing cycles can
be performed until the drawer is emptied.
CLOSE SERV. DOOR
The door is not properly closed.
INS. GROUND DRAWER
The coffee grounds drawer is not properly inserted.
INS. BREW GROUP
The brew group is not properly inserted.
BREW GROUP ERROR
The brew group does not work properly; switch off the
machine
and contact the AUTHORISED SERVICE
CENTRE.