Saeco Aulika SUP040R, Service Manual

Page: 31 / 56

AULIKA 05 FAULT FINDING
Rev. 00 / July 2012 Page / 08
f MV: xx xx.yy.zz
B2B B2B RI DF ER
1 Software
Description of the individual pages
02
SECTOR TYPE
DESCRIPTION
Swiss
FUNCTION
Swiss can be used to activate or deactivate the ECO-MODE default setting.
If Swiss is active, the Eco-Mode default setting is ON, while if Swiss is inac-
tive, the Eco-Mode default setting is OFF.
The hydraulic circuit emptying function brings the ECO-MODE back to the
default value. This default value, as already mentioned, is a function of the
Swiss setting
Pow Off
FUNCTION
It shows whether the machine, once turned on with the electromechanical
switch (I/O), goes in Stand-By mode; if so, the “Pow Off” words are hi-
ghlighted. If it is deactivated, the machine does not go to Stand-By mode
immediately after the Power On.
W.Net S
FUNCTION
If pressed, this key enables/disables the water net system function (if it is
active, then the machine is model B2B RI, if it is inactive, then the model is
B2B).
W.Net A
FUNCTION
If pressed, it operates the 24VDC solenoid valve of the water network
system (actual activation occurs only if: - the grounds drawer and the brew
unit niche drawer are assembled and the side door is closed)
Debug
FUNCTION
If selected, a debug window opens in user mode
ESC
FUNCTION
If pressed, the machine exits Test Mode
f
INFO
Shows the network frequency. It can take the following values:
50 Hz
60 Hz
ERR when the frequency cannot be identified
MV: xx
INFO
shows the EEPROM Memory version
xx.yy.zz
INFO
shows the version of the loaded software
B2B
INFO
If active, it shows that the machine version is B2B
B2B RI
INFO
If active, it shows that the machine version is B2B connected to the water
supply system.
DF
INFO
Gives information of the status of the memory This value must be 64
ER
INFO
Gives information of the status of the memory This value must be 8
1 Software
Swiss Pow Off Debug
W.Net S W.Net A ESC