40
English
Important
If the setting relative to the instant product (“INSTANT
PRODUCT - WATER - % INSTANT PRODUCT”) means
that the powder dispensing lasts longer than the water
dispensing, the vending machine stops powder dosing (to
avoid insufficient rinsing of the mixer) and emits a beep.
Check the settings again to obtain correct dispensing
(powder dispensing must end a few instants before the
water dispensing is complete, to allow good rinsing of the
mixer).
INSTANT PRODUCT DOSE:
This defines the quantity
of instant product to be
brewed.
Example: “005” quantity indicates that the motor of the
instant product 3 will be activated for 5 tenths of a second.
The quantity of instant product is adjustable from “1” to
“100” in steps of 1. Brewing of the instant product does
not occur when the parameter is set at “0000” (in this case
water is brewed).
H2O / INSTANT PRODUCT
It defines the amount of water
to be mixed with the instant
powder.
Example: “3” indicates that water will be mixed with the
instant product 3. “022” indicates that 22 water units will
be brewed with the instant product. The reference unit is
preset by the manufacturer. The amount of water can be
adjusted from ‘“1” to “999” in steps of 1.
SUGAR
This defines the quantity of
sugar to be dispensed with
the beverage.
The following table shows the result of the various
settings.
Settings
Sugar in
beverage without
preselection
Sugar in beverage
with preselection
0
Without sugar
Quantity preselected
1
1
Quantity preselected
2
2
Quantity preselected
3
3
Quantity preselected
4
4
Quantity preselected
Stop sugar
Without sugar
Without sugar
3.3.
Beverage 1
H2O InstPr. 3:022
3.3.
Beverage 1
Instprod D. 3:005
3.3.
Beverage 1
Sugar 2
3.3.
Beverage 1
Test Beverage
BEVERAGE TEST
Enables brewing tests to be
carried out on the beverage
just set.
By pressing ENTER the message “PRESS KEY” is displayed
and it is possible to choose the key to be pressed, relative
to the type of brewing test:
Beverage 1 key = Complete beverage;
Beverage 2 key = Beverage without sugar, stirrer and
cups;
Beverage 3 key = Beverage without powder (soluble/
coffee);
Beverage 4 key = Beverage without water.
SUGAR PRE-WASH
Allows enabling/disabling the
sugar cup pre-wash before
dispensing the beverage.
This allows cleaning the cup from possible dark product
particles in it.
Washing of the sugar cup (mixer) is performed under the
following conditions:
- Functionality for the selected beverage enabled;
- Beverage dispensed with sugar;
- The sugar mixer has been last used to dispense one of the
instant products located next to the sugar container.
The quantity of water used for the wash is a factory preset
value.
3.4.
Sugar pre-wash
