No.
Name
Type
Quantity
Remark
FCP-1000
224×50×5
4
Protection for rigid
connector
FCP-500:
WX-249
42
FCP-1000:
WX-250
5
Inner hexagon
screw
GB/T70.1-200
8-M10×25
49
6
Flat washer
GB95-2002-C-
Ø
10
49
7
Spring washer
GB859-1987-
Ø
10
49
8
Hexagon spanner
8#
1
1Bag
9
Packing list
1 set
10
QC passed
1 set
11
label (1 to 24)
1 set
12
Battery connection
drawing
1set
3 Battery Rack installation procedures:
3.1 Unpacking Caution:
3.1.1 Battery mold rack is assembled before delivery, pay attention when unpacking to avoid mutual bump between
components.
3.1.2 Unit mold rack needs individually stacking installation, this needs disassembled all molds during unpacking.
3.1.3 For easy installation, the battery mold rack can also be the whole installation, or more than one unit mold as
large module decomposition before installation.
3.1.4 The bolts, flat washers, spring washers, nuts and other good which disassembled from the battery mold
should be stored well for use when reinstalling.
3.2 Installation requirement
3.2.1 The distance between battery mold rack and wall should be greater than 100 mm; the distance between one
ends of output line and wall should be more than 300 mm.
3.2.2 If conditions permit, the battery mold rack distance with walls, doors, equipment should be greater than
1000mm;
3.2.3 If the user is required, the battery mold rack can be configured grounding wire, drawn-out position is the
expansion bolts at the bottom of the battery mold rack;