SachsenRad SachsenRad E-Racing R6, User Manual

Page: 12 / 36

12
2.7 Adjusting the saddle height
1. The height of the saddle can be adjusted with the quick-release on the saddle rail. You only need to release
the quick-release lever to freely select the height of the saddle. After you have adjusted the desired height, lock
the quick-release lever again and the adjustment is complete.
2. After the adjustment, make sure that the quick-release lever of the seat post is well locked. The seat post must
not slip.
WARNING: Incorrect installation of the seat post may result in serious injury or death. It is strictly forbidden to
raise the height of the seat post above the safety line.
2.8. About the brake settings
If you are not satisfied with your brakes, please contact your dealer and ask for the intervention of a professional
technician.
2.9 Note on chain tension
Not after the first few rides, but after a certain period of use, the chain may be worn out due to transmission
strength and can be properly adjusted by using a tensioning screw to hold the chain in place. The chain should
be set on the smallest tooth of the flywheel. Turn the rear transmission tensioning screw (see fig. A) clockwise
with a screwdriver. The chain should not sag. Also make sure that the chain is sufficiently greased and clean.
2.10 Lighting and bell
NOTE: If front and rear lights and bell are included in the accessory pack, they must yet be fitted.
Rear light
You will find the battery-powered rear light in the accessory box. Attach it to the seat post below the saddle using
the screwdriver provided. If the clamp of the rear light mount is too loose, use the rubber strip provided. Before
using the rear light for the first time, remove the battery protection strip.
Bell
You will find the bell, if not already installed on the handlebars, in your accessories box. Find a suit-able place on
the handlebar and install the bell in the same way as for the rear light (described above).