Sabre Sabre 30, Owner'S Manual

Page: 17 / 81

3/21/2017 Sabre 30 Owners Manual
17/81
5:03 ___ Start engine. Water temp/oil pressure alarm should activate and shut off when
engine starts.
5:04 ___ Check oil pressure, ammeter charge, fuel and water temperature gauges.
5:05 ___ Check exhaust water flow.
5:06 ___ Inspect engine water cooling system for leaks.
5:07 ___ Inspect exhaust system for water and exhaust leaks.
5:08 ___ Check gear shift lever in all positions and adjust cable if needed.
5:09 ___ Check throttle action and adjust cable if needed.
5:10 ___ Adjust idle speed in accordance with Engine Manual.
5:11 ___ Adjust stuffing box after engine has been run for 10­15 minutes.
5:12 ___ Check bilge for signs of fuel leaks.
5:13 ___ Recheck entire fuel system for leaks.
6:00 FRESH WATER SYSTEMS
6:01 ___ Fill fresh water tank.
6:02 ___ Check action of galley and vanity foot pumps. Note: To avoid damage to foot
pump, faucet shutoff must be open.
6:03 ___ Check water system for leaks.
6:04 ___ Check pressure water faucets and systems (option).
6:05 ___ Commission water heater and check engine drive and 110V AC heating operation
(option).
7:00 HEAD SYSTEM
7:01 ___ Check action of head.
7:02 ___ Check head fill and discharge hoses for leaks.
7:03 ___ Check action of holding tank.
7:04 ___ Check operation of y­valve discharge plumbing and instruct owner on proper
valve positioning (option).
7:05 ___ Activate Lectra/San unit (option) in accordance with instructions. Unit may be
difficult to prime with water. See owner's manual for priming procedure.
8:00 STOVES AND OVENS
8:01 ___ Review stove or oven manual with owner.
8:02 ___ Fill alcohol tank half full.
8:03 ___ Check CNG tank and system (option).
8:04 ___ Check action of all burners.
8:05 ___ Check adjustment of burner control valves.
8:06 ___ Check hoses and control valve packing nuts for air pressure or fuel leaks.
9:00 SEA TRIALS