ELSA
10
Charge Cylinder:
1.
Remove the charging adaptor dust
cover and store safely for use later.
2. Fit the firing pin and quick-fire
strap.
3.
Fit 200 bar G5/8 pattern charging
connector to the charging adaptor.
CAUTION:
DO NOT immerse the cylinder valve.
4. Keep the reducer/cylinder valve
clear of the water and immerse the
cylinder vertically in water so that three
quarters of the cylinder is covered.
5.
Slowly open the compressor supply
valve. Charge cylinders at 40 L/min, (10
min. cylinders should take approximately
10 minutes to charge and 15 min.
cylinders approximately 15 minutes), then
close the compressor supply valve.
6. When the cylinder has cooled
check that it is full. If necessary, open the
compressor supply valve briefly until the
contents gauge shows full.
7.
Close the compressor supply valve,
bleed off pressure from the supply hose,
disconnect the charging adaptor from the
cylinder and fit the charging adaptor dust
cover.
Re-fit Cylinder into Bag:
1.
Remove the cylinder from water,
dry thoroughly and fit it into the bag.
2.
Fit the contents gauge through the
slot in the bag so that the gauge can be
seen clearly when the bag is closed.
3. Feed approximately half of the
breathing hose into the bag.
