#"
Bypass the GRAPHI-Q. If noise is still there, it’s not the
GRAPHI-Q. If noise goes away, check your gain structure.
Make sure the input level to the GRAPHI-Q is robust. Turn down
gain downstream.
Is your GRAPHI-Q in front-panel mode? Load any Stored
Preset other than #1.
Check output level. Most likely you are mixing balanced and
unbalanced connections, which lowers gain 6 dB.
Either your unit is (or was) connected to GRQ-Remote or
switched via contact closure, and the front panel is disabled.
Resume control via GRQ-Remote or contact switch. In a pinch
short the extreme left & right pins of the back panel contact
connector.
Parametric filter linking obeys a set of rules that will make it
difficult for you to accidentally defeat an FBX filter already in
place. See Section 8.3.
The GRAPHI-Q software requires that your computer display
fonts be set to “small.”
Click the “Start” button and select “Settings” and “Control Panel.”
Double-click “Display” and select “Settings,” then click the
“Advanced...” button. Select “Small Fonts” and then OK to all.
Restart your computer.
PROBLEM
SUGGESTION
NOISY AUDIO
FRONT PANEL CONTROLS
DON’T WORK
REMOTE CONTROL DOESN’T
WORK
SIGNAL LOSES GAIN GOING
THROUGH GRAPHI-Q
PARAMETRIC FILTERS DO
NOT LINK
REMOTE SOFTWARE SCREEN
DISTORTED, LETTERS DO NOT
FIT CORRECTLY
Section Ten: Troubleshooting Tips
