!#
Section Eight: Storing & Recalling GRQ Presets
8.6. STORING AND RECALLING GRQ PRESETS
8.6.1. Memory Storage and Recall Options
You may store and recall all settings of the GRAPHI-Q, either within the GRAPHI-Q memory itself, or
as an external file.
8.6.1.1. Storage within the GRAPHI-Q memory. There are two methods of storing memories inside
the GRAPHI-Q itself:
1.
using “Snapshot” memory storage. You may save and recall (load) up to three Snapshots of
GRAPHI-Q settings. Select Snapshot 1, 2, or 3 from the Options Menu, or use the keyboard
shortcuts Shift/F1, Shift/F2, and Shift/F3. To recall Snapshots, select from the Options Menu, or
use keyboard shortcuts Ctrl/F1, Ctrl/F2, and Ctrl/F3.
2.
accessing the Stored Presets screen. This will allow up to 65 additional user-specified memory
configurations to be stored. To open this screen, press F6 on your keyboard, or select Stored Presets
from the Options Menu. The following screen will open:
Preset 0 will always be the sys-
tem default settings, effectively a
blank template with all param-
eters set to “off” or zero. This
configuration will permit remote
control of the GRAPHI-Q from
any computer meeting the mini-
mum requirements (see Section
Seven) with the GRAPHI-Q Re-
mote Control for Windows Soft-
ware installed.
Preset 1 (FRONT PANEL) will
apply only to GRAPHI-Q models
GRQ-3101 and 3102, and not to
the “S” (blank front panel slave)
models. In this setting, the front
panel controls of the GRAPHI-Q will provide the only means of controlling settings; any software-initiated
controls will be ignored. However, any adjustments made on the GRAPHI-Q front panel WILL be
displayed on the Remote Control screens. In addition, any of these adjustments, alone or in combination,
can then be saved to any of the memory locations from #2 to #66. To accomplish this, open the Stored
Preset screen, and use the mouse to select the Program Number/Program Name field. Type in the name
you wish to give your memory, then click on SAVE at the bottom of the screen. You can rename your
configuration without resaving all the parameter settings by typing a new name and pressing the ENTER
key.
If you save a program without naming it, the default name (e.g., Prog 1) will change to an all upper case
version of the same name (e.g., PROG 1).
Programs 2 through 66 will only allow remote control of the GRAPHI-Q, and front panel adjustments made
when the remote control is in command will be ignored. However, loading Preset #1 will return control
to the front panel, and any physical adjustments made on the front panel while it was disconnected will
be implemented at that time.
When loading or saving configurations, the Stored Presets screen will stay open until you close it. This
allows comparisons between different configurations by loading them to active memory and auditioning
the results.