DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
The electronic speed control (ESC) is installed in the front part of the helicopter. The support is made of aluminum, which
further acts as a heat sink for the ESC. The figures below show the installation of three different brands of ESC.
Figure 4
: Shows the wiring which connects the receiver and ESC (in this picture one frame has been removed).
If the BEC used is combined with the ESC, it is recommended to use a dual wire connection.
Figure 5
: The passage of the controller wires to the motor is highlighted.
Figure 6
: Shows the installation of a 2S battery for the flight control system.
Alternatively, a BEC could be placed in the same area.
ESC Cables
2S Battery or BEC
Copyright@2012 - SAB Heli Division - All rights reserved
Page 26
Chapter 10, Installation Of The ESC