A
B
C
DETAIL A
SCALE 1 : 2.5
Spacer
3.1x 15x1.5mm
(H0078-S)
DETAIL B
DETAIL C
SCALE 1 : 2
Metric Hex Nylon Nut M3
Linkage Tail Support
(H0045-S)
Tail Servo Lock
(H0040-S)
......
x2
Socket Head Cap Screw
M2.5x6mm
Set Screw
M3x20mm
(HC150-S)
Metric Hex
Nylon Nut M3
(HC206-S)
Spacer
3.1x 15x1.5mm
(H0078-S)
Metric Hex Nylon Nut M3
(HC206-S)
Tail Boom
(H0092-S)
Tail Boom
(H0092-S)
Locking Element
Tail Assembly
H0041
Double
Sided Tape
Locking Element Tail Assembly .... X 2
Metric Hex
Nylon Nut M3
......
x4
Boom Spacer
(H0082-S)
Set Screw M3x20mm
......
x3
......
x2
Note:
Metric Hex Nylon Nut M3
(HC206-S)
DETAIL A
DETAIL C
Tail Boom Assembly
(H0092-S)
Locking Element Tail
H0041
Attaching H0082-S to the boom:
Pre-assemble the two boom spacers H0082-S with
the M3x20 socket set screw.
Insert into the boom tube completely done up.
Center the holes, then unscrew until there is contact with the walls
Lock everything with the adhesive.
Assemble H0040-S in the boom
Before assembling the two parts in the boom we
suggest tightening the M2.5 screws into the two
plastic parts to pre-thread them. In this way when
you will assemble the tail servo it will be easier to
tighten the screws into the plastic parts. Check
the tail servo can fit, if necessary carefully sand
the hole.
Assemble H0045-S in the boom
Before mounting H0045 on the boom we
suggest to first tighten the M2.5 screws into
the holes to thread them. In this way when
you assemble the part it will be easier to
tighten the screws.
Tail Boom
(H0092-S)
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Copyright@2012 - SAB Heli Division - All rights reserved
Page 20
Chapter 7, Tail