S+S Regeltechnik Rymaskon 200-Modbus Series, User Manual

Page: 52 / 55

RYM ASKON
®
200-Modbus
Modbus Slave User Manual
© S+S REGELTECHNIK GMBH
| THURN-UND-TAXIS-STR.22 | 90411 NÜRNBERG | GERMANY | FON +49(0)911 519470 | www.SplusS.de
Page 52 of 55
5.2. Remote Control Pairing
Each remote control has an ID that is transmitted along with the button code. This ID can be used to pair a certain
remote control with a certain RYMASKON 200 - device. The ID of the Apple remote control can be changed by
pressing Menu and Center button for at least 6s. This will increment the ID by one.
The ID of your remote control can be checked by pressing any button while watching the
ir_remote_control_command register.
If a RYMASKON 200 device gets paired with a certain remote control it will only update the
ir_remote_control_command register and the IRC bit at the short_pressed register when receiving a command
from this remote control.
Pairing can be achieved by pressing Menu and Right button at the remote control for at least 6s while pointing
towards the RYMASKON 200 device. If pairing worked the secondary display will shortly show ‘IRP’ (IR
pairing). The remote ID will be saved internally and the IRCP flag of the config_flags register at address 192
(Table 21 on Page 29) will be set.
The pairing can be canceled by either clearing the IRCP flag or by pressing Menu and Left button for at least 6s. If
the secondary display shows ‘IRUP’ (IR unpairing) shortly the pairing is suspended.