12
4 Installation
10. Connect the hose to the inlet of filter housing #1
secure it with one of the provided hose clamps
(Fig. 19)
11. Use the remaining hose to connect the filter
system to the drain on site. Cut to suitable
length if needed. Connect the hose to the outlet
of filter housing #3 and secure it with one of the
provided hose clamps (Fig. 20).
12. Connect the other end of the hose to the drain/
floor drain according to local regulations.
Figure 19
Figure 20
Figure 21
IMPORTANT NOTES:
• Never use a drain hose longer than 6 m (18 ft).
• Height of wall mounted drain outlet must never
exceed 1,5 m/5 ft from the floor.
• Avoid sharp bends or blocking’s as it may limit
the output flow and cause a raised pressure in
the system.
13. Install lint filter with the sheet metal lip towards
the pump. Slide it down until it comes to a stop
(Fig. 21).
