S-COM 7K, Manual

Page: 39 / 400

Messages
4-13
Send Next Message Slowly
Entering this command before entering a command with a CW
message causes the CW message to be sent slowly.
•
The actual speed is set by the Select Slow CW Speed command on page
4-13.
•
This command is most useful when placed into a macro for users.
•
CW speed returns to normal after the CW memory empties.
Command Form:
Command Form
Send Next Message Slowly (PW) 11 *
Acknowledgment: None
Errors: None
Default Condition: CW is sent at the normal rate
Examples:
Assume that a macro, 3*, exists which sends the 12-hour time. Assume also
that a macro, 2*, exists which contains the
Send Next Message Slowly
command. Then a user could enter:
2 *
3 *
This will cause the time-of-day to be sent at a slower rate than normal.
Note: The repeater courtesy message is also a CW message. If a user enters
2* and then releases the mike, the courtesy message will be sent slowly. Since
the speed then changes back to normal, entering a 3* will cause the time to be
sent at normal. Therefore, the user must enter the 2* and 3* in the same
transmission.