S-COM 7K, Manual, Page: 282 / 400

7K
•
Chapter 21
21-14
User Function: Speak Radio Configuration
Speak the current remote base radio configuration.
•
The current radio settings can be spoken by the controller in one of several
formats.
•
Both abbreviated and detailed information is available.
•
The controller will speak the Frequency or Memory Channel and whether
the Transmitter is On or Off. If On, it will speak the Transmitter Offset.
•
The controller will speak the CTCSS frequency and whether it is enabled for
encode, decode, or both.
Command Form:
Command Form
Speak Frequency and Offset (RBPW) 19 *
Speak Frequency and Offset (RBPW) 19 0 *
Speak CTCSS Frequency (RBPW) 19 1 *
Speak All (RBPW) 19 2 *
Speak Abbreviated Frequency and Offset (RBPW) 19 3 *
Speak Abbreviated CTCSS Frequency (RBPW) 19 4 *
Speak Abbreviated All (RBPW) 19 5 *
Acknowledgment for Detailed Responses:
•
When the VFO of the remote base radio is selected, the actual frequency is
spoken.
•
When a memory channel of the remote base radio is selected, the memory
channel number is spoken.
•
If the transmitter is disabled, the controller says “Transmit Off”.
•
If the transmitter is enabled, the controller speaks the currently selected
offset: “Offset Minus”, “No Offset”, or “Offset Plus”. Special offsets are
supported. On the 1200 band, the controller may say “Offset Minus
Twenty”. On the 440 band, the controller may say “Offset Minus Minus”.
(See your radio manual for when this offset may be selected.)
•
If no CTCSS tone is selected for encode or decode, the controller says
“CTCSS Off”.
•
If a tone is selected for either encode or decode, the controllers says
“CTCSS” and the frequency. For example, for a CTCSS frequency of
123.0 Hz, it says “C T C S S one two three point zero hertz”.
•
If a tone is selected for encode, the controller says “Transmit”.
•
If a tone is selected for decode, the controller says “Receive”.
•
If a tone is selected for encode and decode, the controller says “Transmit
And Receive”.