S-COM 7K, Manual, Page: 124 / 400

7K • Chapter 7
7-30
Access Autopatch (Without Password)
Accesses the autopatch without using the password method.
•
Enter the telephone number, and the star (*), if required. All digits are
entered in a continuous string.
•
The phone number may be up to 35 digits in length, and may contain
special command digits (A, B, C, D).
•
See the Enable/Disable Autopatch Access Without Password command on
page 7-33.
Command Form:
Command Form
Access Autopatch (Without Password) (phone number) *
Acknowledgment: Sends the Autopatch Dialing Message
Errors:
Error Meaning
OFF autopatch is full OFF (disabled)
? REJ rejected (number in Rejected Number Table)
? ERR rejected (number not allowed by AP Call Type)
BZ phone line is busy (Model 7K controller only)
Default Condition: Access Autopatch (Without Password) is OFF (disabled)
Examples:
Assume that a number you wish to call is 456-7890. Enter the following:
4567890 *
When the above command is entered, the controller will screen the telephone
number 456-7890 according to the following tables you may have programmed:
•
Autopatch Call Types Table (page 7-35).
•
Accepted Number Table (page 7-38).
•
Rejected Number Table (page 7-38).
and dial the number.
If the number is not acceptable, the controller will send one of the error
messages cited above.