1
INTRODUCTION—HOW TO USE MANUAL
INTRODUCTION
The information contained in this manual will allow
you to operate and maintain your Rytec Turbo
Slide™ Door in a manner which will ensure
maximum life and trouble-free operation.
Any unauthorized changes in procedure, or failure to
follow the steps as outlined in this manual, will
automatically void our warranty. Any changes in the
working parts, assemblies, or specifications as
written that are not authorized by Rytec Corporation
will also cancel our warranty. The responsibility for the
successful operation and performance of this door is
yours.
DO NOT OPERATE OR PERFORM MAINTENANCE
ON THIS DOOR UNTIL YOU READ AND UNDER-
STAND THE INSTRUCTIONS CONTAINED IN THIS
MANUAL.
If you have any questions, contact your Rytec
representative or call the Rytec Customer Support
Department at 800-628-1909.
Always refer to the
serial number of the door when calling your
representative or Customer Support.
The serial
number is located in several locations-see
DOOR
SERIAL NUMBER
section.
A wiring schematic is provided with each individual
door specifically covering the control panel and
electrical components of that door. See the Rytec
System 4 Drive & Control Installation & Owner
’s
Manual.
HOW TO USE MANUAL
Throughout this manual, the following key words are
used to alert the reader to potentially hazardous
situations, or situations where additional information
to successfully perform the procedure is presented:
WARNING is used to indicate the potential
for personal injury, if the procedure is not
performed as described.
CAUTION is used to indicate the potential
for damage to the product or property
damage, if the procedure is not followed
as described.
IMPORTANT: IMPORTANT is used to relay
information CRITICAL to the
successful completion of the
procedure.
NOTE: NOTE is used to provide additional infor-
mation to aid in the performance of the
procedure or operation of the door, but not
necessarily safety related.
DOOR SERIAL NUMBER
Each RYTEC door is uniquely identified with a serial
number. You will need this when contacting RYTEC
for any service.
To obtain your door’s DOOR SERIAL
NUMBER, there are several typical locations where
the
DOOR SERIAL NUMBER
can be found; on the
cover of the RYTEC System 4 control panel, the front
side outside edge of each door panel at
approximately eye level, and the drive motor/head
assembly. (See Figure 1)
IMPORTANT: When installing multiple doors of
the same model, verify and match
the serial number of the control
panel with those on all the other
components of each door
assembly. Failure to do this will
void the manufacturer’s warranty
and may lead to catastrophic
failure and/or personal injury!
Figure 1
Photo
eyes
Rytec
Control
Panel
Rytec
Door
Panels
Rytec
Motor
Drive
Rytec
Control
Panel
Rytec
Door/Head
Assembly
Rytec
Motor
Drive
Rytec
Door
Panels
Photo eyes
Door
S/N
stickers
