![background image](http://html1.mh-extra.com/html/ryobi/ry3818/ry3818_operators-manual_1504243030.webp)
Page 30 — English
TOP PLATE FILING ANGLE
See Figure 50.
CORRECT 30° – file holders are marked with
guide marks to align file properly to produce
correct top plate angle.
SIDE PLATE ANGLE
See Figure 51.
CORRECT 80° – Produced automatically if you
use the correct diameter file in the file holder.
HOOK – “Grabs” and dulls quickly; increases
the potential of KICKBACK. Results from using
a file with a diameter too small or a file held too
low.
BACKWARD SLOPE – Needs too much feed
pressure; causes excessive wear to the bar and
chain. Results from using a file with a diameter
too large or file held too high.
MAINTAINING DEPTH GAUGE
CLEARANCE
See Figures 52 - 54.
Maintain the depth gauge at a clearance of .025
in. Use a depth gauge tool for checking the
depth gauge clearances.
Every time the chain is filed, check the depth
gauge clearance.
■
Use a flat file and a depth gauge tool to lower
all gauges uniformly. Use a .025 in. depth gauge
tool. After lowering each depth gauge, restore
original shape by rounding the front. Be careful
not to damage adjoining drive links with the
edge of the file.
■
Depth gauges must be adjusted with the flat file
in the same direction the adjoining cutter was
filed with the round file. Use care not to contact
cutter face with flat file when adjusting depth
gauges.
INCORRECT
MORE THAN 30°
TOP PLATE FILING ANGLE
LESS THAN 30°
Fig. 50
30°
CORRECT
INCORRECT
BACKWARD SLOPE
SIDE PLATE FILING ANGLE
Fig. 51
80°
CORRECT
HOOK
FLAT FILE
DEPTH GAUGE TOOL
Fig. 53
Fig. 52
DEPTH GAUGE CLEARANCE
.025 IN.
MAINTENANCE
Summary of Contents for RY3818
Page 40: ...NOTES...
Page 80: ...NOTES...