Ryobi RSCD750, Owner'S Operating Manual

Page: 6 / 12

2
WARNING
WARNING
WARNING
The pump is not suited to discharge salt water,
sewage, flammable, caustic or hazardous liquids.
Please observe the max. temperature of the liquids
to be discharged stated in the technical data.
Inside the pump, lubricants are used which may
contaminate the liquids being discharged in case
of any improper operation or damage of the device.
The lubricants used are biologically degradable and
nonhazardous to health.
During the entire process of installation, the device
must not be connected to the electrical mains. The
pump and the entire connection system have to be
protected from frost.
INTENDED USE
INSTALLATION
WARNING
Make sure the pump is disconnected from electric
power supply before performing maintenance
procedures.
MAINTENANCE
CLEANING THE PUMP HOUSING
Use a moist cloth to wipe down the pump housing.
Allow to dry thoroughly before storing in a dry location
that is protected from bad weather conditions.
■ Ensure all connections are leak free. Use a thread
seal tape (sold separately ) or a suitable sealant on
the connection thread
■ When tightening threaded connections, please
do not apply excessive force which may cause
damage.
■ When laying the connection pipes, you should
■ Avoid inserting hands into the inlets/outlets of the
water pump while it is connected to power.
■ Before using the water pump, always inspect it
visually. Do not use the pump if it is cracked and/or
damaged.
■ The water pump has a built-in thermal protection
overload switch. The water pump stops if an
overload occurs. The motor restarts automatically
after it has cooled down.
■ The pump must not be used when people are in the
water.
■ Never work or perform maintenance on the pump
without first making sure it has been disconnected
from the mains power.
■ Pollution of the liquid could occur due to leakage of
lubricants.
Important: Avoid inserting hands into the mouth of
the pump if it is connected to the mains. The electrical
connection must always be made in a dry area. Make
sure that electrical connections are protected from
inundations.
Protect the plug and the power cable from heat, oil or
sharp edges.
WARNING
The water pump together with associated pipework
operate under pressure. Do not disconnect water
pump or pipework until internal pressure has been
released. Failure to do this could result in personal
injury and damage to property.
■ A distinctive feature of this pump is that it can
briefly operated (max. 4 min.) with liquids with a
temperature up to 95°C (see Technical data).
■ RYOBI Submersible dirty water pumps are highly
efficient electrical pumps for discharging clean or
dirty water containing solids up to the maximum size
specified in the technical details.
■ This pump is intended for discharging clean or dirty
water containing solids up to the maximum size
35mm
■ Typical applications for waste water submersible
pumps are: Emptying ponds, tanks, storage tanks,
and waste water pits, emergency drainage in the
event of flood etc. This product is intended for
household use only, not for extended continuous
operation.
SYMBOLS DEFINITION ON THE PRODUCT