![background image](http://html1.mh-extra.com/html/ryobi/rpht254o/rpht254o_original-instructions-manual_1507223017.webp)
15
OPERATION
1
2
4s
VI
4s
VI
4
3
4
1
2
6
1
2
7
1
2
3
4s
VI
4s
VI
4
5
4. Hold down the throttle lock and then
squeeze the throttle trigger completely
with your left hand and keep the throttle
trigger squeezed completely through
steps 6.
Use your right hand to put the starter
bit shaft to the shaft hole on the engine.
Make sure the starter bit is properly
engaged.
Press and hold the electrical starter
switch button until the engine attempts to
start. Do not press the electrical starter
for more than 4 seconds.
5. Set the choke lever to
choke
position.
Hold down the throttle lock and then
squeeze the throttle trigger.
Press and hold the electrical starter
switch button until the engine starts. Do
not press the electrical starter for more
than 4 seconds.
NOTE:
If the engine does not start,
repeat the procedure again from step
where you set the choke lever to
choke position.
Do not repeat the procedure more than
1 time. If the engine does not start after
the second attempt, see the solution
instruction for the “Flooded engine” in
the “Troubleshooting” section of this
manual.
6. Allow the engine to run for 10 seconds,
and then set the lever to
position.
7. Hold down the throttle lock and then
squeeze the throttle trigger to start using
the product.