Ryobi PBLCS300, Operator'S Manual

Page: 11 / 40

11 - English
ADJUSTMENTS
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when making adjustments.
0° BEVEL STOP
See Figure 23, page 16.
The saw has a 0° bevel stop that has been factory adjusted to
assure 0° angle of the saw blade plate when making 90° cuts.
CHECKING 0° BEVEL STOP

Remove battery pack.

Place the saw in an upside down position on a workbench.

Check the squareness of the saw blade plate to the base
of the saw using a carpenter’s square.
ADJUSTING 0° BEVEL STOP

Remove battery pack.
 Loosen bevel lock knob.

Loosen hex nut securing adjusting screw.
 Turn adjusting screw and adjust base until square with
saw blade.

Tighten hex nut and bevel lock knob securely.
WARNING:
Attempting a bevel cut without having the bevel lock knob
securely tightened can result in serious injury.
ADJUSTING THE DEPTH LOCK LEVER
See Figure 24, page 16.
Over time, due to wear, the depth lock lever may move from
its original setting. If the lever prematurely contacts any part
of the saw during tightening and loosening, adjust the lever
by following these steps:

Remove the battery pack.

Pull depth lock lever upward away from the base to
release.

Pull saw base down to the minimum depth of cut position,
then push the depth lock lever down toward the base to
secure.

Insert a flathead screwdriver into the space between the
lock nut and the E-ring. Remove the E-ring.

Note the position of the lever on the nut. Slide the depth
lock lever off the hex portion of the lock nut.

Rotate the depth lock lever one “flat” clockwise around
the nut. Then slide it back into place on the hex portion.

Push the E-ring back into the groove on the lock nut until
it snaps into place. Take care that the E-ring does not pop
off the lock nut.

Loosen the depth lock lever and return the base to the
full depth of cut position and lock the depth setting by
pushing downward on the depth lock lever. The base
should be locked securely in position when locked and
be free to move when released.
ACCESSORIES
Look for these accessories where you purchased this product or call 1-800-525-2579:


7-1/4 in. Thin Kerf Blade ....................................................................................................................................682142003

Edge Guide Kit ....................................................................................................................................................
204585002
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.