![background image](http://html.mh-extra.com/html/ryobi/p2009/p2009_operators-manual_1507026011.webp)
9 — English
MAINTENANCE
If replacing the bump knob, remove the old knob from
the spool. Align the knob ribs with the spool slots and
place the new bump knob onto the spool. If you are not
replacing the bump knob, skip this step.
Insert the bump knob and spool assembly through the
opening in the string head housing.
Align the slots on the lower string head housing with the
tabs on the upper string head housing.
Push the housing together until the tabs snap into place.
NOTE:
Hold the spool by the knob while completing the
installation.
Install line as described in
Line Replacement
.
STORING THE TRIMMER
Remove the battery pack from the string trimmer before
storing.
Clean all foreign material from the trimmer.
Store it in a place that is inaccessible to children.
Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
Either by hand or using the SPEED WINDER, rotate the
bump knob clockwise to wind the line on the spool until
approximately 6 in. of line is showing on each side.
NOTE:
For best results, after every five to seven revolutions
of the SPEED WINDER, pull both line ends taut for best
loading results and to help prevent line from tangling.
Push the bump knob down while pulling on line(s) to
manually advance the line.
CLEARING LINE JAM AND/OR REPLACING
BUMP KNOB
See Figures 12 - 13.
Remove the battery pack.
Depress the tabs on the side of the string head housing
to remove the lower string head housing.
NOTE:
The housing is spring loaded and will self eject
when the tabs are depressed. It is not necessary to remove
the upper string head housing from the drive shaft.
Push the spool and bump knob through the string head
housing and remove the string from the spool.
Summary of Contents for P2009
Page 33: ...NOTES NOTAS ...