4 — English
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the following purposes:
Charging EverCharge
™
Tools with Ryobi One+ 18V Li-ion
or Ni-Cd battery packs installed
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
OPERATION
MOUNTING THE WALL CHARGER
See Figures 1- 3, page 7.
WARNING:
Make sure the charger is mounted high enough to
prevent unauthorized activation of the tool being charged.
Unauthorized activation of the tool can result in serious
personal injury.
Find desired location indoors and away from any objects
that could block vents on charger. Locate a wall stud to
securely mount charger.
NOTE:
Do not place the charger in an area of extreme
heat or cold. It will work best at normal room temperature.
You will need two #8 - 2 1/2 in. screws (not included).
Use a level to be sure that charger is in a vertical position. Use
a pencil to mark screw hole placement and install top screw.
Place the wide portion of the key hole over the head of
the top screw.
Slide the charger down until the screw is inside the narrow
portion of the key hole.
Check the orientation of the charger and install bottom
screw into the screw hole.
CHARGING BATTERIES
See Figure 4, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use.
If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest repair center for electrical check.
Charge time is approximately 5 hours and is dependent upon
the type of battery pack.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
