The battery-powered pneumatic hammer drill can be
used universally for hammer drilling and drilling as well
as for screwdriving in wood, metal and plastic. This
pneumatic hammer dill is not suited for chiselling work
(also not with pointed chisels).
WARNING
When using battery-driven tools basic safety
precautions are to be taken, including the
following, in order to reduce the risk of fire,
batteries leaking and persons becoming injured.
Before operating the machine, please read the operating
instructions completely, follow the Safety Instructions in
this manual as well as the general Safety Instructions for
Power Tools.
Important instructions, which should be read before
starting operation, and which we strongly
recommend observing:
Keep work area clean.
Cluttered areas and benches
invite injuries.
Keep children away.
Do not let visitors touch the tool.
All visitors should be kept away from area.
Do not force the tool.
It will do the job better and
safer at the rate for which it was intended.
Use the right tool.
Do not force small tools or
attachments to do the job of a heavy duty tool. Do not
use tool for purposes not intended.
Dress properly.
Do not wear loose clothing or
jewellery, they can be caught in moving parts. Rubber
gloves and non-skid footwear are recommended
when working outdoors. Wear protecting hair
covering to contain long hair.
Secure work.
Use clamps or vice to hold the work.
It is safer than using your hand and it frees both
hands to operate the tool.
Do not overreach.
Keep proper footing and balance
at all times.
Stay alert.
Watch what you are doing. Use common
sense. Do not operate tool when you tired.
Check damaged parts.
Before further use of the
tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment breakage of parts, mounting and any other
conditions that may affect its operation. A guard or
other parts that is damaged should be properly
repaired or replaced by an authorised service centre
unless otherwise indicated in this instruction manual.
Have defective switches replaced by an authorised
service facility. Do not use the tool if the switch does
not turn it on and off.
Disposal of battery.
Ensure battery is disposal of
safely as instructed by the manufacturer.
For charging the batteries, only use a charger
which is recommended by the manufacturer
and
never use the recommended charger to charge other
electrical equipment.
Never carry the tool with your finger on the switch.
Before commencing any work on the machine
itself, remove the battery.
Do not use any defective or deformed batteries.
Any machines and batteries that are not being
used should be kept separately in a dry place that
is high up or locked, out of the reach of children.
For safety's sake, a battery charger connected to the
mains should also be permanently supervised.
Do not expose the machine, battery and battery
charger to rain.
Do not use the machines in a wet or
damp environment.
Always keep the battery and battery charger clean
and dry.
Do not open the battery and protect from impact.
Protect the battery from heat and fire: Danger of
explosion!
Do not place the battery on radiators or
expose to strong sun rays for a longer time;
temperatures over 50
°
C cause damage.
In extreme conditions battery fluid can leak out.
This does not mean it is defective. If in such a case
the casing is no longer sealed and battery fluid comes
into contact with the skin, proceed as follows:
- Wash affected skin immediately with soap and water.
- Neutralise the battery fluid with vinegar or lemon juice.
- If the eyes are affected, rinse with clear water with
at least 10 minutes. Consult a doctor immediately!
Before connecting the charger to the mains,
please check that the voltage of your mains
connection corresponds to the voltage stated on
the name plate of the charger.
Always inspect the plug and cable before use.
If damaged, they must be replaced by a qualified
professionals.
Caution
High voltage: Do not open the battery charger!
2
RULES FOR SAFE OPERATION
