![background image](http://html.mh-extra.com/html/ryobi/bs904/bs904_operators-manual_1506358014.webp)
14 — English
ADJUSTMENTS
ADJUSTING BLADE GUIDE ASSEMBLY
See Figures 17 - 18, page 21.
To prevent the blade from twisting or breaking, the blade
guide assembly should always be set approximately 1/8 in.
above the workpiece.
Turn the lock knob counterclockwise to unlock the blade
guide assembly.
As a guide, use a scrap piece of the same wood you are
about to cut to set the height of the blade guide assembly.
Adjust the blade guide assembly by turning the blade
guide knob.
Lock blade guide assembly in place by turning the lock
knob clockwise.
Always lock the blade guide assembly in place before
turning on the band saw.
ADJUSTING BLADE GUIDE SUPPORT AND
THRUST BEARINGS
See Figure 19, page 22.
NOTE:
Tighten the lock knob and refer to
Adjusting Blade
Tension
and
Tracking the Blade
procedures explained in
the
ASSEMBLY
section of this operator’s manual prior to
making adjustments.
The upper and lower blade thrust bearings support and
bearing guides the saw blade during cutting operations. The
adjustment of the bearings and guides should be checked
whenever a different blade is installed.
To Adjust Thrust Bearings:
The thrust bearings support the back edge of the blade
during cutting. The blade should not contact the thrust
bearings when you stop cutting. It is important that both
upper and lower thrust bearings be adjusted equally.
Open the front covers and blade guard.
Using a hex key, loosen the upper and lower thrust
bearing screws and push thrust bearings to the back of
the saw.
Verify that saw blade is tracking correctly, then slide the
thrust bearing forward until the bearing is within 1/64 in.
of the blade. Tighten the thrust bearing screw securely.
Slide lower bearing forward until it has proper clearance.
Tighten the thrust bearing screw securely.
To Adjust Blade Guide Support:
Loosen the blade guide support and blade guide set
screws using hex keys.
Slide the upper blade guide support on the shaft until the
front edge of the guides contact the saw blade behind
the gullet. Tighten the screw securely.
Push the right guide to contact the blade and release.
Slowly rotate wheel one full rotation. Tighten blade guide
set screws.
Adjust left side guide to allow 1/64 in. clearance between
the blade and guide (about the thickness of a dollar bill)
by inserting dollar bill between left guide and blade.
Apply pressure to left guide pin to hold dollar bill in place.
Tighten set screw and remove dollar bill.
Rotate, by hand, a full three rotations to make sure blade
will not bind.
Close the blade guard and front cover. Relatch.
Repeat this procedure for the lower blade guide support.
Summary of Contents for BS904
Page 53: ...23 NOTES NOTES NOTAS ...
Page 54: ...24 NOTES NOTES NOTAS ...
Page 55: ...25 NOTES NOTES NOTAS ...