ASSEMBLY INSTRUCTIONS
9
Decal
Screws
ADJUSTING THE J-HANDLE
The J-handle is assembled on this model
not
in the correct position. Use the following
instructions to adjust the J-handle to the
correct position.
1. Loosen the four (4) mounting screws
on the J-handle.
2. Slide the J-handle until the arrow/bar on
the decal is flush to the edge of the clamp
assembly (Fig. 1).
3. While holding the unit in the operating
position (Fig. 2), adjust (rotate) the handle
forward and back to a position that
provides you the best grip.
4. Tighten the mounting screws.
Fig. 1
Fig. 3
Fig. 2
INSTALLING THE HARNESS
WARNING:
Always use the shoulder
harness when using the cutting
blade to avoid serious personal
injury.
1. Push the strap through the center of the
buckle.
2. Pull the strap over the cross bar and down
through the slot in the buckle (Fig. 3).
3. Snap it on to the support fitting (Fig. 4).
4. Adjust length to fit the operator’s size. Pull
tab to lengthen, pull strap to shorten (Fig 5).
Fig. 4
Fig. 5