MAINTENANCE AND REPAIR INSTRUCTIONS
19
2. Wind the lines, in even and tight layers,
onto the reel (Fig. 32). Wind the line in the
direction indicated on the inner reel. Be sure
not to overlap the two ends of the line.
NOTE:
Place your index finger between
the two lines to stop the lines from
overlapping.
NOTE:
Failure to wind the line in the direction
indicated will cause the cutting head
to operate incorrectly.
3. Insert the ends of the line into the two
holding slots (Fig. 33).
Reinstalling the Reel
1. Insert the ends of the line through the eyelets
in the outer spool and place inner reel inside
the outer spool (Fig. 34). Then grasp the
ends and pull firmly to release the line from
the holding slots in the spool.
NOTE:
The spring must be assembled on
the inner reel before reassembling
the string head.
2. Hold the inner reel in place and install
the Bump Knob in the
counterclockwise
direction (see Fig. 28). Line installation
is now complete.
INSTALLING PREWOUND REEL
1. Follow the instructions in
The Correct Line
to Use
.
2. Follow the instructions in
Removing the
Existing Reel
.
3. Follow the instructions in
Reinstalling the
Reel
.
Fig. 32
Fig. 34
Fig. 33
