OPERATING INSTRUCTIONS
15
NOTE:
Aligning the release button with guide
recess will help installation (Fig. 21).
2.
Basic trimming or using other Ryobi
attachments -
Locate and lock the release
button into the primary hole in the Click-Link
(Fig. 22).
3.
Edging with the trimmer head attachment
-
Locate and lock the release button into the
90˚ edging hole
or
180˚ edging hole
in the
Click-Link (Fig. 23).
CAUTION:
Make sure the release
button is locked in the primary hole
and knob is securely tightened
before operating this unit.
CAUTION:
All attachments are
designed to be used in the primary
hole unless otherwise indicated in
the attachment’s operator’s manual.
If the incorrect hole is used, it
could result in injury, or damage
to the unit.
4. Tighten the knob securely
clockwise
before
using the unit (Fig. 23).
OPERATING THE CLICK-LINK
®
SYSTEM
This unit is equipped with a Click-Link
®
System,
which enables optional attachments to be
installed on the unit. The optional attachments
are:
Blower/Vacuum . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . HS720r
Snow Thrower . . . . . . . . . . . . . . . . . . . ST720r
Straight Shaft Trimmer . . . . . . . . . . . . . SS725r
Sweeper/Blower . . . . . . . . . . . . . . . . . . SB720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . TP720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . TB720r
WARNING:
To avoid serious
personal injury, shut off the unit
prior to removing or installing
any attachments.
Removing the Lower (Attachment) Boom
NOTE:
To make removing the boom easier,
place the unit on the ground or on
a workbench.
1. Loosen the knob
counterclockwise
(Fig. 21).
2. Press and hold the release button
in
(Fig. 21).
3. While firmly holding the upper boom, pull
the lower boom straight out of the Click-Link
(Fig. 22).
Click-Link
Click-Link
Release Button
Guide
Recess
Knob
Primary Hole
Upper
Boom
Lower
Boom
Release
Button
90˚
Edging
Hole
Knob
180˚
Edging
Hole
Fig. 21
Fig. 22
Fig. 23
If your unit is not assembled, or you
have more than one attachment, use
the following instructions:
Installing the Lower (Attachment) Boom
1. Remove the hanger from the lower
(attachment) boom. Hold the release button
in
while pushing the lower (attachment)
boom into the Click-Link (Fig. 22).
