Rx Clear HydroSalt, Installation & Operation Manual

Page: 22 / 24

21

Salt level too low (below 2500 ppm, Low Salt LED on).

Salt level too high (high Salt LED on).

Low pH. Low pH oxidizes chlorine quickly, making it difficult to maintain desired
chlorine levels. Adjust pH levels to re-balance water.

Warm pool water increases chlorine demand—increase Desired Level% or
filter run time.

Cold water (below 50F) can cause HydroSalt
™
to stop generating (Generating
LED flashing).

Excessive scaling on cell.

High level of phosphates in pool water.

Some yellow algae treatments will use chlorine at a very high rate and deplete
the residual free chlorine. Manually shock the pool if indicated in the directions
on the algae treatment. It still may be a matter of days before the pool returns to
“normal” and chlorine tests will show the desired 1-3ppm free chlorine reading.
9. “PCB” displayed and all 4 LEDs are illuminated.
A possible printed circuit board fault has been detected. Call for service.
REPLACEMENT PART LIST
Item No. Part description