10
POLYMERS:
It is advised to use polymers (commonly sold as poly algaecide) on salt water sanitizing
systems. The poly algaecide is sold in 30% and 60% concentrations.
Application rate is 1 quart of Poly30 (or ½ quart of Poly 60) per 15,000 gallons (60,000
liters) of pool water, per month. Apply directly in front of the return jet.
CONTROLS
MAIN SWITCH
AUTO:
For normal operation, the Main switch should be left in the AUTO
position. In this position the HydroSalt
™
will produce chlorine according to the
“Desired Level %” adjustment setting for the entire filtering / pumping cycle.
SUPER CHLORINATE:
When you have an abnormally high bather load, heavy
rainfall, cloudy water conditions, or any other condition which requires that a
large amount of purification be introduced, set the Main Switch in the SUPER
CHLORINATE position. This electronically “super chlorinates” (shocks) the
water for 24 hours (filter pump must be on during this time) or until the power
has been turned off, whichever comes first. At the end of the super chlorination
period, be sure to put the switch back into the AUTO position.
OFF:
The OFF position prevents the HydroSalt
™
from energizing the
electrolytic cell. In this position there is no chlorine generation.
NOTE:
In times of servicing, the OFF switch is not to be used. To service the HydroSalt
™
,
turn power off the circuit breaker.
DESIRED LEVEL ADJUSTMENT KNOB
This setting is used to control the amount of chlorine the HydroSalt
™
generates. Adjust
this setting to increase or decrease the chlorine output level. The reading is from 5
percent output to 100% output capacity of the HydroSalt
™
.
Summary of Contents for HydroSalt
Page 18: ...17...
