Russell Hobbs RHFP5000, Instructions & Warranty

Page: 8 / 28

8
USING THE DISCS IN THE LARGE WORKBOWL
1. Lock the large workbowl into place.
2. Fit the blade shaft onto the centre post in the large workbowl.
3. Using the 2 large round holes to hold the disc you wish to use,
with the desired side up (slice or shred/grate), place the disc onto the blade shaft (G).
4. Place lid on workbowl and lock into place by rotating counterclockwise.
5. Place food in feed chute and use food pusher to guide foods towards the slicing/shredding
disc.
6. Press the button for speed 2; press slowly and steadily on food pusher to guide food
through the food processor.
Note: Heavy pressure on the pusher does not speed up the work; use the pusher only as a
guide. Let the food processor do the work.
7. When finished, press OFF|PULSE and allow the disc to stop revolving and unplug the
appliance before removing the lid. Rotate the lid clockwise to unlock, and remove it from
the workbowl.
8. Carefully remove slicing/shredding disc using the finger holes to lift straight up. Pull blade
shaft out of the workbowl. Unlock the workbowl by turning it clockwise and lift off base.
9. Empty the workbowl.
10. Unplug appliance when not in use.
USING THE DISCS WITH THE SMALL WORKBOWL
1. Lock the large workbowl into place on the food processor base.
2. Fit the blade shaft onto the centre post in the large workbowl.
3. Place the small workbowl into the large workbowl, fitting the tabs
on the outside of the small bowl into the notches on the large
workbowl. This will hold the small bowl firmly in place. (H)
4. Carefully place the slicing/shredding disc onto the blade shaft. (I)
5. Place the lid onto the workbowl and lock the lid into place by
rotating it counterclockwise.
6. Follow remaining steps as indicated in USE THE DISCS IN THE
LARGE WORKBOWL.
Note:
Lift up the blade shaft to remove the small workbowl from the large workbowl.