5
CRUSHING ICE
Start with half to threequarters of a cup of ice, or 4 to 6 cubes and add 15ml
of fresh cold water.
Put the lid on the blender, then:
1.
Turn the speed control to
Y
for a second or so then release it.
2.
Check the state of the ice.
3.
Repeat till the ice is the consistency that you need.
USING THE MILL
1.
Turn the mill upside down and unscrew the collar.
2.
Remove the blade unit and seal.
3.
Put the ingredients into the bowl (dry ingredients only).
4.
Lower the blade unit and seal on to the bowl.
5.
Screw the collar on to the bowl and tighten firmly.
6. Turn the mill right way up and lower it onto the motor unit. Turn it
clockwise to lock it in place.
7.
Turn the speed control to
Y
in short bursts till you achieve the size of
grind you want.
8.
Let the speed control return to
O
, and wait till the blades stop moving
9.
Turn the mill anti-clockwise to unlock it then lift it off the motor unit.
10. Turn the mill upside down.
11. Tap the mill a couple of times to move all the ground ingredients into
the bowl.
12. Unscrew the collar and remove the blade unit and seal.
13. Empty the bowl.
OVERLOAD PROTECTION
This appliance is fitted with a device to protect it in the event it becomes
overloaded or overheats. If the appliance stops without warning for any
reason, do the following:
1.
Switch off (
O
) and unplug the appliance.
2.
Allow the appliance to cool down for 15 min
3.
Once cooled down the protection device will automatically reset and
the appliance can be used normally again.
CARE AND MAINTENANCE
Switch off (
O
) and unplug before cleaning.
1.
Turn the jug anti-clockwise to unlock, and lift it off the motor unit.
2.
Handwash the jug, lid and cap.
