Rush Pin 1 CW, User Manual

Page: 9 / 16

RUSH PIN 1 CW user manual 9
Physical installation
The fixture is designed for indoor use only and must be used in a dry location
with adequate ventilation. Always ensure that the fixture’s heat sink is not
covered and always ensure that the product is firmly affixed.
The fixture should be mounted via its screw holes on the bracket.
Fastening the fixture to a flat surface
The fixture can be fastened to a hard fixed flat surface that is oriented at any
angle. Ensure that the surface can support at least 10 times the weight of all
fixtures and equipment to be installed on it.
Fasten the fixture securely. Do not stand it on a surface or leave it where it can
be moved or fall over. Attach a securely anchored safety cable to the fixture if
it is installed in any location where it may fall and cause injury or damage if the
primary attachment fails.
Mounting the fixture on a truss
The fixture can be clamped to a truss or similar rigging structure in any
orientation. When clamping a fixture to a truss:
1. Check that the rigging structure can support at least 10 times the weight of
all fixtures and equipment to be installed on it.
2. Block access under the work area.
3. Rig the fixture using clamps and hardware suitable for the purpose.
Working from a stable platform, hang the fixture on the truss. Tighten the
rigging clamps and hardware.
4. Secure the fixture against clamp failure with a secondary attachment such
as an approved safety cable that is rated for the weight of the fixture.