Rush Pin 1 CW, User Manual

Page: 12 / 16

RUSH PIN 1 CW user manual 12
To clean the fixture:
1. Disconnect the fixture from power and allow it to cool for at least 10
minutes.
2. Vacuum or gently blow away dust and loose particles from the outside of
the fixture and the air vents at the back and sides of the head and in the
base with low-pressure compressed air.
3. Clean the LED lenses by wiping gently with a soft, clean lint-free cloth
moistened with a weak detergent solution. Do not rub the surface hard: lift
particles off with a soft repeated press. Dry with a soft, clean, lint-free cloth
or low-pressure compressed air. Remove stuck particles with an
unscented tissue or cotton swab moistened with glass cleaner or distilled
water.
4. Check that the fixture is dry before reapplying power.
Service and repairs
There are no user serviceable parts inside the fixture. Do not open the housing.
Never try to repair the fixture by yourself as this may result in damage,
malfunction and it may potentially void your product warranty. The equipment
must only be serviced or repaired by an authorized RUSH by Martin service
technician.
Installation, on-site service and maintenance can be provided worldwide by
the Martin Professional Global Service organization and its approved agents,
giving owners access to Martin’s expertise and product knowledge in a
partnership that will ensure the highest level of performance throughout the
product’s lifetime. Please contact your RUSH by Martin supplier for details.
Troubleshooting
This section describes a few common problems that may occur during
operation and provides some suggestions for easy troubleshooting:
Symptom Potential cause Remedies
No light from fixture. Power supply issue,
such as blown fuse,
faulty connector or
damaged cable. Ensure that the mains
supply is connected and
supplying power to the
fixture.
Check all power
connections and cables.