16
RUSH PAR 2 CT Zoom™ User Manual
level in the menu structure without making a change, press the MENU
button.
•
To exit the menus, press and hold the MENU button.
DMX addressing
The DMX address, also known as the start channel, is the first channel used
to receive instructions from a DMX controller. You control the fixture by
sending signals from a DMX controller over this channel and the channels
immediately above it – seven channels in total. If you give the first fixture
DMX address 1, it will use channels 1 to 7. DMX address 8 is available for
the next fixture, address 15 for the next fixture and so on.
If you want independent control, you must give each fixture its own DMX
address. If you want grouped control and identical fixture behavior, give
fixtures the same DMX address.
To set the fixture’s DMX address:
1. In the fixture’s control panel, use the UP and DOWN buttons to select
DMX ADDRESS and press ENTER. The fixture’s currently set DMX
address will blink in the display.
2. Use the UP and DOWN buttons to select a new address.
3. Once the new address has been selected, press ENTER to confirm it (or
press MENU to exit without making a change).
Dimming curves
Four dimming curves are available:
•
MODE 1: LINEAR – The increase in light intensity appears to be linear
as DMX value is increased.
•
MODE 2: SQUARE LAW – light intensity control is finer at low levels and
coarser at high levels.
•
MODE 3: INVERSE SQUARE LAW – light intensity control is coarser at
low levels and finer at high levels.
•
MODE 4: S-CURVE – light intensity control is finer at low levels and high
levels and coarser at medium levels.
MODE 1
MODE 2
MODE 3
MODE 4
